doc: renamed project

pico-sensor/McuLib/config/McuArmToolsconfig.h

@@ -0,0 +1,45 @@
+/**
+ * \file
+ * \brief Configuration header file for Kinetis Tools (or ARM in general)
+ * Copyright (c) 2020, Erich Styger
+ * SPDX-License-Identifier: BSD-3-Clause
+ *
+ * This header file is used to configure settings of the ARM Tools module.
+ */
+
+#ifndef __McuArmTools_CONFIG_H
+#define __McuArmTools_CONFIG_H
+
+#if !defined(McuArmTools_CONFIG_PARSE_COMMAND_ENABLED)
+  #define McuArmTools_CONFIG_PARSE_COMMAND_ENABLED  (1)
+    /*!< 1: shell support enabled, 0: otherwise */
+#endif
+
+#if McuLib_CONFIG_NXP_SDK_2_0_USED
+  /* will include system header file in the implementation file */
+#elif McuLib_CONFIG_SDK_VERSION_USED==McuLib_CONFIG_SDK_KINETIS_1_3
+  /* will include system header file in the implementation file */
+#elif McuLib_CONFIG_CPU_IS_ARM_CORTEX_M
+  /* include here the low level CMSIS header files, e.g. with */
+  #if McuLib_CONFIG_CPU_IS_STM32
+    #include "stm32f3xx_hal.h" /* header file for STM32F303K8 */
+  #elif McuLib_CONFIG_SDK_VERSION_USED==McuLib_CONFIG_SDK_NORDIC_NRF5
+    #include "nrf.h"
+  #endif
+#endif
+
+#ifndef McuArmTools_CONFIG_STACK_CHECK_PATTERN
+  #define McuArmTools_CONFIG_STACK_CHECK_PATTERN  (0xdeadbeef)
+    /*!< Byte pattern on stack, to mark it is 'unused' */
+#endif
+
+/* The two symbols below shall be set by the linker script file to mark top and bottom of stack. Note that the two addresses need to be 32bit aligned! */
+#ifndef McuArmTools_CONFIG_LINKER_SYMBOL_STACK_TOP
+  #define McuArmTools_CONFIG_LINKER_SYMBOL_STACK_TOP  _vStackTop
+#endif
+
+#ifndef McuArmTools_CONFIG_LINKER_SYMBOL_STACK_BASE
+  #define McuArmTools_CONFIG_LINKER_SYMBOL_STACK_BASE _vStackBase
+#endif
+
+#endif /* __McuArmTools_CONFIG_H */